ep

January 4, 2021

one.A connecting website link of an O-ring Chain for general application is pre-coated with grease in the pins. Prior to connection, confirm the grease to the surfaces of pins, and should the volume of grease is modest, apply grease with bare hands. (If gloves are utilized, the grease will probably be absorbed from the gloves.)
Example: When the connecting hyperlink (I) of an O-ring chain for basic application is
shipped, O-rings are fitted at the roots in the pins. If the O-rings come loose as a consequence of vibration in the course of transport, refit the O-rings in to your roots with the pins.
In this case, you should definitely return the grease collected in the roots of the pins to the central surfaces on the pins, more at portion A than at portions B shown within the over illustration. (Portions A is worn as a result of sliding together with the bushings.)
2.The chain is usually most quickly linked over the teeth of a sprocket. Engage the hyperlinks at the two ends on the chain together with the sprocket teeth and fit connecting pins. When the sprocket is often moved, the chain may also be connected to the loosened side.
three. Connecting procedure
one.Confirm that O-rings are connected on the roots on the pins.
two.If the quantity of grease applied on the connecting pins is little, coat the pins with grease at the central portions.
three.Insert the connecting pins in to the bushings with the inner backlinks at the two ends.
4.Confirm the grease is applied for the total face on the O-ring, and match the O-ring onto the connecting pins.
five.Insert the connecting pins in to the connecting plate and when pressing the connecting plate, install the spring clip. Confirm no matter if the head (the finish without a split) on the spring clip is turned in the feeding route of the chain. (See the following illustration.)
six.Make sure you verify the spring clip is securely fitted during the clip grooves on the connecting pins.
This completes jointing of the connecting website link. Note that grease over the surfaces of connecting pins and O-rings can be eliminated throughout installation get the job done. In this instance, re-grease applying the grease on the surface on the base chain or the grease in the polyethylene bag in which the connecting website link was contained.